Section 1: Product and Company Identification

Product:

CorrectDeck & CorrectDeck CX

Manufacturer:

Correct Building Products
8 Morin St.
Biddeford, ME 04005
Ph:207-284-5600

Preparation Date:

May, 2000

Section 2: Composition, Information on Ingredients

Component Name:

CAS #, Composition Amount
Wood Fiber(Sawdust): NA, 50-60%
Polypropylene: 9003-07-0, 40-50%

Section 3: Hazards Identification

In normal use, the product is not hazardous. However, this product may be cut or finished in ways which produce wood dust fibers. Certain wood fibers are considered hazardous if the airborne concentration exceeds the OSHA or ACGIH exposure limits for long periods of time. Exposure to such fibers is considered unlikely with this product; all sawdust in the board is fully stabilized in the plastic resin matrix.

Section 4: Emergency and First Aid Procedures

Inhalation:

This material is not expected to present an inhalation hazard.

Eyes:

Flush sawdust or fines from eyes with water; if irritation occurs, obtain medical attention.

Skin:

This material is not expected to present a skin contact hazard.

Ingestion:

No adverse affects expected from ingestion.

Section 5: Fire and Explosion Data

Flash Point:

Greater than 650F.

Upper Explosive Limit:

Not Determined

Lower Explosive Limit:

Not Determined

Auto Ignition Temperature:

Estimated to be greater than 650F.

Extinguishing Media:

Dry Chemical, Water Fog, Foam, Carbon Dioxide.
Special Fire Fighting Procedures: Dense smoke emitted when burned without sufficient oxygen.
Possible dust explosion if fines accumulate. Wear standard fire fighting attire (as for fighting a wood fire), including SCBA gear in enclosed areas.
NEPA Hazard ID: Health:0 Flammability:1 Reactivity:0

Section 6: Spills and Disposal Notification Procedures

Land Spill:

Material should be swept up and discarded.

Water Spill:

Clean up and discard or reuse.

Waste Disposal:

Dispose of in accordance with local regulations. No special procedures required.

Section 7: Handling and Storage Handling

CorrectDeck is heavier than normal wood. Lift carefully.
Storage: Support every two feet on a flat surface. Store away from strong oxidizing agents or combustible materials.

Section 8: Protective Measures

Ventilation:

Use in well ventilated area.

Respiratory Protection:

An approved respirator may be needed in areas with a high accumulation of fines.

Eye protection:

Wear safety glasses with side shields when sawing or installing.

Skin protection:

No special precautions needed.

Section 9: Physical Data Appearance and Odor

Slight hardwood odor.

Boiling Point:

NA

Solubility in Water:

Insoluble

Vapor Pressure:

Negligible

Melting Point:

285-330F

Vapor Density:

NA

Percent Volatile:

Negligible

Section 10: Reactivity Stability

This material is stable.

Conditions to Avoid:

Heat and flame

Materials to Avoid:

Strong oxidizing agents

Combustion Products:

Hazardous Polymerization: Will not occur.

The following combustion products may be generated:

carbon dioxide, carbon monoxide, water vapor, trace VOC's, Formic Acid, Acetic Acid.

Section 11: Toxicological Data

Exposure Limit of Material Not established LD50 of Material Not established Carcinogenity of Material None (wood dusts are fully stabilized in the polymer matrix)

Section 12: Ecological Considerations

This material has not been tested for environmental effects.

Section 13: Disposal Considerations

Dispose of as normal refuse.

Section 14: Transport Information:

This material is not regulated by DOT.

NEPA Hazard ID: Health:0 Flammability: 1 Reactivity: 0

Section 15: Regulatory Information

WHMIS Classification: This is not a controlled product. This material is not hazardous by OSHA Hazardous Communication Standard 29 CFR 1910.1200. This material is not subject to specific CERCLA, California Safe Drinking Water and Toxic Enforcement Act (Proposition 65) or SARA 313 reporting requirements.

To the best of our knowledge the information contained in this Material Safety Data Sheet is accurate. However, neither Correct Building Products, LLC nor any of its affiliates makes any warranty, express or implied, or accepts any liability in connection with this information or its use.