Penofin penetrating oil wood finish is formulated to enhance and protect the natural beauty of any variety of wood. Use Penofin oil wood finish on any exterior wood surface where a transparent finish with ultraviolet protection is needed.

• Brazilian Rosewood Oil penetrates deeply to protect against moisture.

• Hardens and protects individual wood fibers.

• Transoxide pigments virtually eliminate the fading due to sunlight.

• Penofin won't fade, turn chalky, or wash off.

• No surface film to trap moisture or cause chipping and peeling.

• Wide range of transparent and semitransparent colors.

Blue Label Oil Wood Finish is available in ten colors.

• SHAKE PRODUCT WELL BEFORE USING. DO NOT add thinning or blending agents.

• Apply Penofin to a clean, dry surface. Surface must be free of dirt and sawdust build-up. DO NOT APPLY IN DIRECT, HOT SUNLIGHT (when wood is hot to the touch).

• Brush on, use a stain pad, or spray on (garden or pump airless sprayers) one coat of Penofin.

• For maximum penetration wait 30 minutes, then use a nap-free shop cloth and wipe the entire surface removing any excess product.

• Surface will be dry to the touch in three hours and ready for use in 12 hours

• When using the one-coat formula, the application is now complete.

• If using the two-coat formula, wait a minimum of three hours and apply a light second coat and again wipe any excess from the entire application area.

  Caution & Warnings
  

• Combustible - keep this product away from heat, open flame, and sparks.
• Beware of spontaneous combustion. Make certain all rags or other materials used with Penofin are soaked in water, stored in an air-tight container, or otherwise disposed of safely.

  Gallon Coverage
  Smooth surfaces: 200-300 square feet. Rough surfaces: 125-175 square feet (a gallon) for both coats of Oil Wood Finish.

  Product Performance
  Expect 2-4 years on vertical surfaces, 9-18 months on horizontal surfaces depending on use and weather exposure.